in both the oss and bin folders. everything seemed to go ok. Then when I open it, im hit with "Scanning CD-ROM devices" and it will never find any.
After reading around here some I found a lot of people were saying there were bugs and to use older versions. So I uninstalled and tried again with progressively older versions. This is where i don’t know what’s going on. i will run the same make sudo make install commands, read the eula, type "yes", and MakeMKV will NOT be installed. Its not in the menue, "makemkv' in the terminal is not a command and nothing exists at "/usr/bin/makemkv".
16442496 wrote: Sat Nov 14, 2026 3:26 am
For makemkv-oss
Did you first run?
./configure
Yes, i did. should have mentioned that.
Woodstock wrote: Fri Nov 13, 2026 10:40 pm
Version 1.18.x and 1.17.x both have better history of working.
i did go over that actually. to be precise i have tried
1.18.4
1.18.2
1.17.7
1.17.6
and
1.17.4
all exhibiting the same behaviour of getting through the terminal installation without me being able to spot any error message, yet not actually getting installed
At any rate, i tried version 2 again because it was the one that got the farthest. After much frustration i found that i can get further than the "Scanning CD-ROM devices" only if i start the program with the DVD tray extended out. closed empty or closed with dvd both get stuck for some reason. idk why though
16442496 wrote: Tue Nov 17, 2026 5:44 am
And it wasn't that Blu-Ray drive firmware/SDF_Stop Forever Bug after all.
Actually the fact that MakeMKV shows "LibreDrive Information" for this "second drive" (but not the other one) suggests that it was most likely the "SDF_Stop Forever Bug". AFAIK the bug occurs whenever a drive is "possibly" LibreDrive (but not "exactly" / "currently" / "enabled"). (It does not occur whenever MakeMKV has no way to check whether a drive "can be" a LibreDrive -- in which case no "LibreDrive Information" section appears.)
I never have multiple drives connected to a system simultaneously though so I have no idea whether a "problematic" drive can prevent MakeMKV from working "at all".
"I never have multiple drives connected to a system simultaneously though so I have no idea whether a "problematic" drive can prevent MakeMKV from working "at all"."
I have two drive system and just tested with v.2.0.0.
MakeMKV opens and works normally, even when there is one drive that needs "older mmkv version/firmware/SDF_stop". and you do nothing of those.
Both my Pioneer BD-ROM drives are one of these:
"LibreDrive Information
Status: Possible, but very unlikely to happen
Drive platform: Pioneer RS1003
Firmware version: ID58"
Mabe it need to set: Ask for single drive mode and select drive that works.