Verbatim 43888 Firmware 1.05 Don't Flashing

[Eze2kiel]

Hello everyone.
I have a recently acquired Verbatim 43888.

Here is the log from MakeMKV:

Drive Information
OS device name: J:
Manufacturer: HL-DT-ST
Product: BD-RE BU40N
Revision: 1.05
Serial number: ----
Firmware date: 2124-04-23 13:47
Bus encryption flags: 17

LibreDrive Information
Status: Possible, not yet enabled
Drive platform: MT1959

I'm following the steps to flash it, but I keep encountering various errors—for example:
Internal error 0x83000001
Command Procedure error code 0x82052400

Could someone provide some guidance on how to flash it correctly?

[MartyMcNuts]

Hello everyone.
I have a recently acquired Verbatim 43888.

Here is the log from MakeMKV:

Drive Information
OS device name: J:
Manufacturer: HL-DT-ST
Product: BD-RE BU40N
Revision: 1.05
Serial number: ----
Firmware date: 2124-04-23 13:47
Bus encryption flags: 17

LibreDrive Information
Status: Possible, not yet enabled
Drive platform: MT1959

I'm following the steps to flash it, but I keep encountering various errors—for example:
Internal error 0x83000001
Command Procedure error code 0x82052400

Could someone provide some guidance on how to flash it correctly?

What are you using to flash it? A flashing tool or command line? If the latter, what is the command you are using?

Also note, you should not use MakeMKV v2.0.0 for flashing. Use MakeMKV v1.18.4.

[Eze2kiel]

Hello everyone.
I have a recently acquired Verbatim 43888.

Here is the log from MakeMKV:

Drive Information
OS device name: J:
Manufacturer: HL-DT-ST
Product: BD-RE BU40N
Revision: 1.05
Serial number: ----
Firmware date: 2124-04-23 13:47
Bus encryption flags: 17

LibreDrive Information
Status: Possible, not yet enabled
Drive platform: MT1959

I'm following the steps to flash it, but I keep encountering various errors—for example:
Internal error 0x83000001
Command Procedure error code 0x82052400

Could someone provide some guidance on how to flash it correctly?

What are you using to flash it? A flashing tool or command line? If the latter, what is the command you are using?

Also note, you should not use MakeMKV v2.0.0 for flashing. Use MakeMKV v1.18.4.

I used command line.
Later see the Thread viewtopic.php?t=22896 and finally flashing correctly!.

Drive Information
OS device name: J:
Manufacturer: HL-DT-ST
Product: BD-RE BU40N
Revision: 1.03
Serial number: -----
Firmware date: 2118-10-24 19:34
Bus encryption flags: 17

LibreDrive Information
Status: Enabled
Drive platform: MT1959
Firmware type: Patched (microcode access re-enabled)
Firmware version: 1.03
DVD all regions: Yes
BD raw data read: Yes
BD raw metadata read: Yes
Unrestricted read speed: Yes

Many thanks!.