Asus BW-16D1HT : Stuck in Boot Mode

[Psyire]

I followed this youtube video: https://www.youtube.com/watch?v=jyQV1aPlbow&t=222s

Flashed my Asus BW-16D1HT to 3.10, it said 100% Finished and just stayed there. (never moved on to "Done Successfully") So I'm assuming it didnt' go 100% according to plan.

I did not use "enc" because it was not listed as an encrypted firmware from what I could tell.

Now the drive just says "Boot" in MakeMKV and the light continually flashes, drive won't open or close.

Anyway I can re-flash or reset somehow?

[Psyire]

Well.. I figured out the issue. The drive was manufactured in 2013. Doh! It was purchased second hand from a guy who said he bought it in 2019. I guess I shouldn't have taken his word for it and looked at the date on the drive. (it was in a computer case that I bought)

Any way to covert this back to original or is it borked for good?

[zittrig]

Sounds to me that you flashed a MT-1939 drive. Old technical platform. I think it's electronic waste.

You can try it with the DOS flash solution but this is no fun and needs some older technical requirements..... described here..... viewtopic.php?f=16&t=19634

[Psyire]

Thanks for the inf zittrig. Unfortunately I can't find any DOS flashing info in the link you provided.

Has anyone brought one of these older Asus drives out of boot mode before?

[dcoke22]

It is down near the bottom in a section titled "only use the recovery steps for older NS40 drives!!:"

There's a link to a video in there too.

It is probably also important to know an Asus BW-16D1HT drive is really an LG drive on the inside. Asus doesn't make their own drives; they're rebadged LG drives.

[Psyire]

Thank you! I didn't know it was an NS40 drive...