Archgon MD-8107S-U3YC-UHD (BU40N)

Forum for discussions about UHD-capable dives
Post Reply
Ananova
Posts: 7
Joined: Sat May 15, 2021 5:17 am

Archgon MD-8107S-U3YC-UHD (BU40N)

Post by Ananova »

Hope I'm posting in the right place.

I just used the SDF Tool Flasher to downgrade the 1.01 Firmware that came on this drive to the DE_LG_BU40N_1.00.bin firmware from the DE Firmware pack.
It seemed to run smoothly and the Flasher said it was successful.

When I go to Disk Management in Windows 10 and check under Hardware ID it still shows the drive as 1.01.

Did the flash work OK or am I missing something ?

Thanks
Billycar11
Posts: 4397
Joined: Sun Aug 24, 2014 5:49 am

Re: Archgon MD-8107S-U3YC-UHD (BU40N)

Post by Billycar11 »

What does makemkv say
Buy a UHD drive from the guide and how to video maker: https://www.makemkv.com/forum/viewtopic ... 20&t=17831
UHD Drives Guide: https://www.makemkv.com/forum/viewtopic ... 16&t=19634
Auto flash kit $25 Email me for one Billycar5924@gmail.com
Ananova
Posts: 7
Joined: Sat May 15, 2021 5:17 am

Re: Archgon MD-8107S-U3YC-UHD (BU40N)

Post by Ananova »

Thanks so much for responding.

Update - I flashed to 1.00, then rebooted my PC. I checked Disk Management and it said 1.01.
I shut down my PC overnight, and when I re-checked this morning , Disk Management now reads 1.00.

Guess it's a Windows thing.
dcoke22
Posts: 3177
Joined: Wed Jul 22, 2020 11:25 pm

Re: Archgon MD-8107S-U3YC-UHD (BU40N)

Post by dcoke22 »

I'd guess the cold boot cycle is what did the trick. Rebooting your machine generally won't restart the tiny computer inside your optical drive. Powering off the machine, however, will power off the optical drive. When it powers on again, the drive boots up from the drive's firmware.
Chris Kelly

Re: Archgon MD-8107S-U3YC-UHD (BU40N)

Post by Chris Kelly »

This confirms/justifies my compulsion/need to turn my computer completely off after modifying hardware connected via PCIe, SATA, and USB.
MartyMcNuts
Posts: 2951
Joined: Wed Nov 22, 2017 11:45 pm

Re: Archgon MD-8107S-U3YC-UHD (BU40N)

Post by MartyMcNuts »

For USB connected drives, just unplug the USB cable plug(s) from PC (or pull the plug from the back of the drive) for a few seconds after flashing. This does the trick. No need to reboot PC.
Cheers :D
----------------------------------------------------------------------------------------------------------------------------
For UHD enabled drives (AU/NZ/SG + Others) & DIY Single Drive Flasher (WW): https://uhdenableddrives.com
Post Reply