How to fix the reading errors? I get errors only on specific Blu Ray Discs.

[White_Gandalf42]

Hi,

I am using a techpulse120 drive with libre drive enabled. So far I could process all of my dvd and blu ray discs, but one.
I tried cleaning the disc multiple times, but the errors persist. I noted that the errors occured at different positions each time I tried to rip the disc. Is this an indication, that the errors are fixable?

Laufwerksinformation
OS-Gerätename: \Device\CdRom0
Aktuelles Profil: BD-ROM
Produzent: HL-DT-ST
Produkt: BD-RE BU40N
Revision: 1.00
Serienummer: MOANBID4909
Firmware-Datum: 2116-12-20 15:28
Markierungen der Bus-Verschlüsselung: 17
Highest AACS version: 10

LibreDrive Information
Status: Enabled
Drive platform: MT1959
Firmware type: Original (unpatched)
Firmware version: 1.00
DVD all regions: Yes
BD raw data read: Yes
BD raw metadata read: Yes
Unrestricted read speed: Yes

Disk-Informationen
Label: ESCAPE_PLANET_APES
Zeitstempel: 2008-11-12 08:14:16
Schutz: AACS v9, BD+ v2008.11
Datenkapazität: 32.62 Gb
Disk-Typ: BD-ROM
Anzahl der Layer: 2
Kanal-Bitlänge: 74,5 nm (max. 25.0 GB pro Layer)

Fehler 'SCSI-Fehler - MEDIUM ERROR:L-EC UNCORRECTABLE ERROR' trat auf während des Auslesens von '/BDMV/STREAM/00013.m2ts' bei Offset '5734858752'
Fehler 'Betriebssystemfehler - STATUS_DEVICE_DATA_ERROR' trat auf während des Auslesens von '\Device\CdRom0' bei Offset '5734858752'

Thanks for your help.

Kind regards
Robert

[Rosebl]

It appears that your drive and LibreDrive setup are functioning properly, but those shifting read errors typically indicate a potential disc issue—either minor scratches, dirt in the protective layer, or manufacturing defects. If cleaning doesn’t help, try lowering the read speed (using MakeMKV or tools like AnyDVD/ImgBurn) or another drive, since some drives handle bad sectors better. If errors keep moving around, it often means the disc is physically marginal, but sometimes still ripable with patience and multiple passes.

[White_Gandalf42]

Changing speed and/or read buffer size didn't change the result. I tried another ten times to rip the Blu Ray disc.
AnyDVD is not supported anymore, so I won't try it.
Therefore, I am still stuck with the error and it's changing offset locations.

Any more ideas, that I can try?

[MartyMcNuts]

Changing speed and/or read buffer size didn't change the result. I tried another ten times to rip the Blu Ray disc.
AnyDVD is not supported anymore, so I won't try it.
Therefore, I am still stuck with the error and it's changing offset locations.

Any more ideas, that I can try?

If a thorough cleaning of the disc with soapy water doesn't help, it's probably a faulty disc.