Version 1.15.0: Error ripping 3 brand new Blu-rays

[intelligo]

I just attempted to rip three brand new Blu-rays using version 1.15.0 for the first time and all three ended with the same error popup:



MakeMKV created no output file in the target directory. The three BDs are:

• Anchorman: The Legend of Ron Burgundy
• Galaxy Quest
• Scott Pilgrim vs. the World

I'm running (Windows 10) and my BDR is an internally installed Pioneer BDR-209M. Attached is the dump from MakeMKV. Please advise. Thanks!

Up until version 1.15.0, MakeMKV has functioned without problems. I will probably revert to the previous version until this problem is resolved.

[Woodstock]

Two things. First, your destination drive is full, and MakeMKV can't write the whole BD to it. You need to free up some space.

Second, you're using a Pioneer drive, and MakeMKV saw that it has a firmware version that Mike doesn't have yet, so the program wants you to send a copy of it to svq@makemkv.com for analysis. Posting it in a forum message isn't the fastest way to get it to him, and Mike will probably have a follow-up request to generate a full firmware dump.

I know this because I have gone through this before. The firmware part, that is.

[intelligo]

Thanks, Woodstock! I'm an idiot!

I almost always have excess disk capacity, and the log's font is so small that I didn't think it could have been a full disk.

[Woodstock]

Hey, running out of space is a chronic disease for rippers...

(I've removed well over 4TB of raw MKVs in the last few days, as I get around to processing them with handbrake)