sdf command does not give any output

[maxreadyy]

Hey there, I am working with a LG BH16NS55, trying to get from 1.05 to 1.02. I have everything installed on my Ubuntu machine and have problems with sdf.bin. When running

Code: Select all

makemvcon f -d /dev/sr0 -f ./sdf.bin rawlash enc -i ./1.02.bin --verbose

, I only get "Loaded SDF.bin version 0x98" and then nothing. I waited for about 10 minutes, so I think there is something wrong here.

Thank you for your help!

[dcoke22]

Does your command really use 'rawlash' or is that a typo?

[Kintsugisys]

Does your command really use 'rawlash' or is that a typo?

I've been having the same issue. OP's typo aside, the system should be returning some kind of status. Instead it hangs forever I've been having the same experience under 1.17.8. I had to downgrade to 1.17.6 before I could flash my drive.

[spkbd]

Does your command really use 'rawlash' or is that a typo?

I've been having the same issue. OP's typo aside, the system should be returning some kind of status. Instead it hangs forever I've been having the same experience under 1.17.8. I had to downgrade to 1.17.6 before I could flash my drive.

Registered just to second this experience. I was able to flash drive when downgrading to 1.17.6, where 1.17.8 would just hang