ASUS BW-16D1HT Timeout Mid-transfer

[Ilikethestars]

I am using an ASUS BW-16D1HT. I followed the instructions in this forum to change the firmware so that LibreDrive mode is enabled -- firmware: 3.10. (Thank you all so much for the amazing instructions and program to make this happen!)

Everything works wonderfully until approximately 5-10 minutes into the saving process, it then freezes and gives me this error:

STATUS_DEVICE_NOT_CONNECTED

I have seen many posts about this code on here but I've found a weird difference: if I click anywhere on the dialogue screen every minute or so, this error does not occur and completes process just fine. It seems that my BD is timing out or something.

I did see in the "ultimate flashing guide" that there is a "sleep bug" mention and fix...though what I am encountering seems to be different than what is described there, and the fix does not make sense to me.

My question is: is there a known way to fix this particular sleep issue or will I just have to continue clicking every minute or so for every transfer?

[Billycar11]

is this drive connected with usb in an external case?

[Ilikethestars]

is this drive connected with usb in an external case?

Not a case but an external USB 3.0 DC powered Vantec SATA adaptor.

[Billycar11]

is this drive connected with usb in an external case?

Not a case but an external USB 3.0 DC powered Vantec SATA adaptor.

Try turning off USB selective suspending in your power plan

[Ilikethestars]

is this drive connected with usb in an external case?

Not a case but an external USB 3.0 DC powered Vantec SATA adaptor.

Try turning off USB selective suspending in your power plan

That did the trick! Thank you very much for the assistance, Billycar11.