Is it possible to change the name of a drive?

[thejm]

Hey guys,

I have a few UHD drives that I use to rip blurays with. I flashed 2 of them with the same FW because it was the only recommended one on the downloads page. As a result they both show up as the same drive in the MakeMKV dropdown list. Is it possible to change and or choose the name of the drive?

It would be super nice to be able to change this:

Code: Select all

BD-RE HL-DT-ST BD-RE WH16NS60 1.02

to something like

Code: Select all

TOP BD-RE HL-DT-ST BD-RE WH16NS60 1.02

or

1 BD-RE HL-DT-ST BD-RE WH16NS60 1.02

Thanks in advance for the replies!
JM

[Billycar11]

well in windows you just identify by the drive letter in singe drive mode

[thejm]

well in windows you just identify by the drive letter in singe drive mode

Ya and I try to do that but thats not shown once you start a RIP so its still hard to identify. Would be a lot easer to make the display name slightly different.