My current firmware version is 1.03.
So, I’ve followed the guide using cmd as admin and it seemed to successfully flash the MK firmware (with "enc" command). But it somehow didn’t got applied? I made a screencast of this process.
First, my drive did not make a 'restart' noise after the flashing and the process was faster than in the tutorial video. Then after the flash, even after a complete system restart, my drive is still using the 1.03 firmware:
Code: Select all
Revision: 1.03
Serienummer: KLWIB9G2100
Firmware-Datum: 2117-11-20 17:04
Markierungen der Bus-Verschlüsselung: 17
Highest AACS version: 72
LibreDrive Information
Status: Possible (with patched firmware)
Drive platform: MT1959
Harware support: Yes
Firmware support: No
Firmware type: Original (patched version available)
Firmware version: 1.03
DVD all regions: Possible (with patched firmware)
BD raw data read: Possible (with patched firmware)
BD raw metadata read: Possible (with patched firmware)
Unrestricted read speed: Possible (with patched firmware)