The Martian - Canadian distribution
Posted: Wed Dec 30, 2015 2:31 am
It took a very long time to even recognize the disc, which usually takes only a few seconds. For the last 10 minutes it has been trying to open the disc. The top bar is titled 'Processing BD+ code' and the bottom one is 'Opening Blu-ray disc'. Shows 4 mins left and counting upward by a seconds per second.
The dialogue shows:
MakeMKV v1.9.8 win(x64-release) started
Using direct disc access mode
Error 'Scsi error - ILLEGAL REQUEST:COPY PROTECTION KEY EXCHANGE FAILURE - KEY NOT ESTABLISHED' occurred while issuing SCSI command AD010..084002400 to device 'SPTI:\Device\CdRom0'
Both disc and drive require bus encryption, but the bus key is not known.
Loaded content hash table, will verify integrity of M2TS files.
Loaded 102 SVQ file(s)
Processing BD+ code, please be patient - this may take up to few minutes
Processing BD+ code using generic SVQ from builtin/00000.svq
Anyone have any ideas on what I can give a try?
The dialogue shows:
MakeMKV v1.9.8 win(x64-release) started
Using direct disc access mode
Error 'Scsi error - ILLEGAL REQUEST:COPY PROTECTION KEY EXCHANGE FAILURE - KEY NOT ESTABLISHED' occurred while issuing SCSI command AD010..084002400 to device 'SPTI:\Device\CdRom0'
Both disc and drive require bus encryption, but the bus key is not known.
Loaded content hash table, will verify integrity of M2TS files.
Loaded 102 SVQ file(s)
Processing BD+ code, please be patient - this may take up to few minutes
Processing BD+ code using generic SVQ from builtin/00000.svq
Anyone have any ideas on what I can give a try?