Hi everyone,
I am trying to open one of my DVDs in manual mode because MakeMKV does not fine it normally.
But I am not sure how to do the syntax for the titles.
I am using v1.17.0
Title six is the correct the correct one based of of the length of the movie but for some reason it will not work correctly.
Title information
1: 1/1 - 2 chapter(s) 0:01:02 2 cell(s)
2: 1/2 - 2 chapter(s) 0:00:26 2 cell(s)
3: 1/3 - 1 chapter(s) 0:00:00 1 cell(s)
4: 1/4 - 11 chapter(s) 5 PGC(s) 4(0:01:49) 5(0:02:59) 6(0:02:24) 7(0:01:11) 8(0:34:35)
5: 1/5 - 1 chapter(s) 0:02:34 1 cell(s)
6: 2/1 - 13 chapter(s) 1:39:16 13 cell(s)
7: 3/1 - 2 chapter(s) 0:02:34 2 cell(s)
But when I enter 6 under "Enter the string descripting titles and/or chapters(cells) you would like to open. Starts to print out.
Using direct disc access mode
Open DVD manually : "6"
Cells 1-1 were removed from title start
Complex multiplex encountered - 12 cells and 6691 VOBUs have to be scanned. This may take some time, please be patient - it can't be avoided.
Title #6 (1:39:16) was skipped due to navigation error
Failed to open disc
Error 'Scsi error - ILLEGAL REQUEST:READ OF SCRAMBLED SECTOR WITHOUT AUTHENTICATION' occurred while reading 'BD-RE HL-DT-ST BD-RE BP60NB10 1.02 SIM03M4FA3923' at offset '1048576'
Using direct disc access mode
Failed to open disc
The disc reads perfectly fine in any DVD player as well as in VLC. I have also tried DVDFab with no luck. I would really apricate any help or recommendations if possible.