www.makemkv.com

Hi guys,

The new release of 1.9.3 doesn't work for me under OS X Yosemite to the point where I can't actually rip a Blu-Ray anymore.

The software just basically freezes during the decryption process at random stages, but mainly during reading of the .cci file or related files. I have tried to restart without success, it keeps freezing with my cpu being used at 100%. I then went on and re-downloaded and installed the previous version 1.9.2 and everything works fine and dandy and it's copying away like a charm.

It would be nice if this could be looked into, I am sure I am not the only mac user that experiences these problems. I tried multiple Blu-Rays, including Blu-Rays that already got ripped in the old version and they didn't work either and now with the backdated version, all my stuff works again

All the best,
Vya

Works for me.
Make 1.9.3 on 10.10.3 and a Buffalo Drive.

I could not use MakeMKV (1.9.2) for one week, I inserted a AACS v54 BD.
After that I could not read any BD's anymore, even those who could be read before.
MakeMKV 1.9.3 works pretty well and successfully read the AACS v54 BD.

Thanks for the comparison

I am on the same config but a matshita drive, so that could be one potential source perhaps. I will test again in the next version and report back!

All the best,
Vya

I have exactly the same problem.

I was in the process of copying the Alien Anthology box set using MakeMKV 1.9.2. The first disc copied fine. I updated to 1.9.3, and then failed to copy all the remaining discs. The symptoms were the same as yours: freezing on a small 2k file early in the copy process. As a further check, I loaded three other random Blu ray discs and experienced the same problem.

Today, I reverted to version 1.9.2 and the copy process appears to be going fine.

I am running Mac OS X Yosemite 10.10.3 on a Mac Pro (Mid 2010), using a Samsung external USB BD drive model TSSTcorp BDDVDW SE-506CB.

I am having the same problem backing up a disc with 1.9.3. Same as others - worked the first time and then started getting this message at the beginning of the backup.

Mike, can you advise something - maybe deleting the preference files and a fresh install of the program?

Thanks!

MakeMKV v1.9.3 darwin(x86-release) started
Debug logging enabled, log will be saved as /Users/stevenimac/MakeMKV_log.txt
Optical drive "BD-RE HL-DT-ST BD-RE BE14NU40 1.01d" opened in OS access mode.
Backing up disc into folder "/Users/stevenimac/Movies//backup/BLADES_OF_GLORY"
Loaded content hash table, will verify integrity of M2TS files.
Loaded content hash table, will verify integrity of M2TS files.
DEBUG: Code 0 at 0Fz':Gj^-j\WC0;c:213139828
DBG ASSERT: Is:U*1Rc^'5YQ,I4w3`P^,!9d36bon"f%!`.1zb_kE-K) at 0Fz':Gj^-j\WC0;c:29403797

Hi guys,

just as an update: Upgrading to 1.9.4 has resolved this issue for me! It seems it was a driver issue after all then, according to the release notes!

All the best,
Vya