MakeMKV just won't work.

[science-nerd]

Has this issue been fixed yet ? I am still experiencing the same issues. I have made sure I am part of the CD rom groups ect..
VLC can see my drive and play dvd's just fine and so does k3b and dvdbackup apps.
The problem is Makemkv complains about not able to get full access to drive and just wont load the disc when entered.
I have tried Ubuntu , Arch , Debian , MInt and it just wont run Makemkv properly. I boot into WIndows and whammo it magically works.
Any one get it working in linux lately and what is the work around?
Thanks..

Is your sg kernel module loaded?

Code: Select all

sudo modprobe sg

Makemkv runs fine on Arch based distros (in my case CachyOS), installed from AUR or pre-compiled from chaotic-aur.

If you need flashing, you will need to use v1.17.7. You can check how to run both latest and this version simultaneously viewtopic.php?f=3&t=40977

[red-lichtie]

Why? Really, why?

I bought a license years ago, although I didn't have to because I believed in what was being done here.

Now I am forced to either use an unsupported/expired/unmaintained version (1.17.7) or home that there is some strange "Libre" firmware for my drive (which there isn't and apparently never will be).

So again, why? Why break MakeMKV like this?

Where is the Libre in forcing a firmware down your users throats? Especially if the drive isn't supported by it?

Now my BluRay drive is basically useless because someone decided to stop supporting the products used by their users. And I thought enshitification was the domain of cloud providers and cloud services.

Simple question, when will "non-Libre" drives be supported again?

[16442496]

I have paid key and i use Non-Libre BD-Drives with newest MakeMKV 1.18.3 on one my machine. Works fine.

What i did:
1. Install MakeMKV 1.17.6 (Add Paid Key)
2. Open MakeMKV and put DVD in.
3. Wait MakeMKV to get firmware file.
4. Install newest MakeMKV 1.18.3 and enjoy.

Backup that .MakeMKV directory or atleast that BD-drive firmware.

[red-lichtie]

I have found a way to get the latest version (1.18.3) working.

Edit .MakeMKV/settings.conf and add your drives name to "sdf_Stop",

In my case it looks like this:

Code: Select all

sdf_Stop = "TEAC_BD-W26SS-B_2.02_{serial number}"

With that, the original functionality returns.

[16442496]

I have found a way to get the latest version (1.18.3) working.

Edit .MakeMKV/settings.conf and add your drives name to "sdf_Stop",

In my case it looks like this:

Code: Select all

sdf_Stop = "TEAC_BD-W26SS-B_2.02_{serial number}"

With that, the original functionality returns.

I tested this and it works if you have only one drive. With two drives you get "endless spin".