Problem after backup

Discussion of advanced MakeMKV functionality, expert mode, conversion profiles
Post Reply
georgesgiralt
Posts: 62
Joined: Thu Jun 04, 2020 12:40 pm

Problem after backup

Post by georgesgiralt »

Hello Guys,
I've tried to backup a Blu-Ray movie "The Spy gone north" A Korean film.
Backup went smoothly and reported no errors.
But I can't visualise any m2ts file with VLC. All I get is the yellow band moving from right to left and left to right on the progress bar. The total play time stays at zero whatever the file I try to see.
Some help will be appreciated.
Many thanks in advance for your help.

Image
Ezatoka
Posts: 409
Joined: Fri Dec 06, 2019 6:55 pm

Re: Problem after backup

Post by Ezatoka »

Did you make a decrypted backup? Because I can still see the AACS directory
georgesgiralt
Posts: 62
Joined: Thu Jun 04, 2020 12:40 pm

Re: Problem after backup

Post by georgesgiralt »

I don't know. I clicked on the backup icon. (the one with the arrow pointing to the open folder).
I'll try again tomorrow and see what gives.
Edit : i did this on Ubuntu 22.04 LTS using the latest Make MKV version.
MartyMcNuts
Posts: 2870
Joined: Wed Nov 22, 2017 11:45 pm

Re: Problem after backup

Post by MartyMcNuts »

georgesgiralt wrote:
Mon May 13, 2024 5:47 pm
I don't know. I clicked on the backup icon. (the one with the arrow pointing to the open folder).
I'll try again tomorrow and see what gives.
Edit : i did this on Ubuntu 22.04 LTS using the latest Make MKV version.
When you click that button there will be a little screen popup for the output directory. There's also a checkbox to decrypt the files. This must be checked!!
Cheers :D
----------------------------------------------------------------------------------------------------------------------------
For UHD enabled drives (AU/NZ/SG + Others) & DIY Single Drive Flasher (WW): https://uhdenableddrives.com
georgesgiralt
Posts: 62
Joined: Thu Jun 04, 2020 12:40 pm

Re: Problem after backup

Post by georgesgiralt »

Yes, my bad. The check box was not checked. But the message is very misleading in French...
It is running fine now.
Thank you both.
Post Reply