Page 1 of 1

Ripping to smb location no longer works

Posted: Sun Feb 09, 2014 9:51 am
by Tinface
After upgrading to 1.8.8 from 1.8.7 I get a 'folder does not exist' (or something to that effect) whenever clicking the start rip button to an smb location. The save popup to pick a target location will not allow a smb location. When selecting my NAS in the tree to the left I get an error about the host not being found.

Regards

Re: Ripping to smb location no longer works

Posted: Sun Feb 09, 2014 9:31 pm
by Woodstock
What operating system?

My MakeMKV operations are usually to SMB shares, although the NAS shares are slower than saving to my Linux or Windows boxes. Version 1.8.8 did not change that on Windows, although I always have the share mapped before-hand. I have not tried doing it to a raw URI handle.