www.makemkv.com

Woodstock wrote:Do you have debug logging turned on?

Yes, the above was with debug logging. However, since posting I've worked out that not all my USB ports are equal as far as my blu-ray drive is concerned. Plugging directly into a different port on the back of the machine got the disc to read happily.

On trying to rip a disc (Terminator Genisys), I get a constant stream of debug messages logged, and the disk just pins endlessly when put in the blu-ray drive. I've tested this disc separately with two different USB connected blu-ray drives. This is the debug log messages, from MakeMKV 1.9.7:- DEBUG...

To clarify further, I think I spoke too soon (again), Just tried this on another system (laptop) with the same Blu-Ray drive (USB attached). This has different versions of many of the system libs, as I haven't upgraded for ages, and a different version of MakeMKV. The problem disc (The Tournament) f...

I was fairly certain that wasn't the problem, as I've had no problem getting discs to rip previously. However, I've now tried this again with the failed disc (recently purchased) and with an older disc I had already ripped, and I am indeed getting the same error on both. So, something has changed......

I have a recently acquired Blu-Ray that fails. On insertion of the disc, you can hear the drive going through the same access cycle multiple times before eventually giving up, and MakeMKV show the disc spinning, but eventually (after 2-3 times longer than it normally take to open the disc) it gives ...

Output below. I also note that it takes a *long* time before it comes up with the "no disc inserted" message - it sits and spins for some time. rootfs / rootfs rw 0 0 sysfs /sys sysfs rw,nosuid,nodev,noexec,relatime 0 0 proc /proc proc rw,nosuid,nodev,noexec,relatime 0 0 udev /dev devtmpfs...

Attempting to rip a newly purchased Blu-ray, I now get a "no disk inserted" error from MakeMKV. It can still see other discs fine, but not this one. On insertion, the drive spins up and it thinks about things for a while, but it then can't see the disk. I enabled debug logging, and got thi...